Every technician is IICRC certified and has handled attic water damage many times. You get a clear plan before any work starts.
You focus on your home. We put together the photos, readings and reports your insurance company needs.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Bronx technician will explain the next step and what it should cost.
Attic water damage comes from two directions. From above, rain enters through failed flashing, worn shingles, or the seals at chimneys and vents. Moisture also rises from the house below and condenses on cold roof sheathing when the attic is not ventilated well. Either way, hardly anyone goes up there to look. Our team in Bronx inspects the attic, finds the source, and dries it out.
On the typical attic job, soaked insulation is the main issue. Heating and cooling bills go up because cellulose and fiberglass alike give up R-value when wet. Worse, soaked insulation holds water against the ceiling drywall and the framing for weeks. We remove what is saturated, dry the wood with air movers and dehumidifiers, and treat any mold on the rafters or sheathing.
To learn whether you have a leak, condensation or the two together, we go over the roof deck, the vents, the exhaust ducts and each flashing point. Thermal imaging and moisture meters show how far it reached.
Saturated or moldy insulation is bagged and removed so the wood and drywall under it can dry. Rooms under the attic are protected, and the route in and out stays contained.
Rafters, sheathing and joists are dried by air movers and dehumidifiers until their moisture levels are normal. An antimicrobial goes on after any visible mold has been cleaned from the wood.
We point out the roof or ventilation problem that needs correcting and can share our findings with your roofer. Once the attic stays dry, new insulation goes in to restore the R-value.
Rain that makes it through the roof falls into the insulation and is absorbed. With no sign inside the house, nobody notices the leak and the roof stays unrepaired.
Damp wood and paper facing in a warm, still attic are ideal for mold. The sheathing, along with the top face of the drywall ceiling, is where growth can begin.
Once storm after storm has saturated the insulation, the ceiling starts getting wet. Brown rings appear in the room below, and the drywall may start to sag.
Roofing nails loosen as the sheathing delaminates. Mold spreads across large sections of the roof deck, and the rafters remain damp enough to decay.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Call (301) 287-5610| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Cellulose insulation | Only the surface is damp and it is still loose | Soaked through or packed down, which is most of the time |
| Rafters and joists | Surface staining or light mold on wood that is still sound | Visible cracks, or rot soft enough for a screwdriver to sink in |
| Ceiling drywall | A dry, flat stain that can be sealed and repainted | Weeks beneath saturated insulation, or any sagging or crumbling |
| Roof sheathing | Only stained, still firm, and reading normal once it has dried | It dips between rafters, feels soft, or has begun to delaminate |
| Fiberglass insulation | A small patch wet by clean rain and dried quickly | Any mold, dirt or matting, or wetness lasting past a few days |
Attics hold junction boxes, recessed light housings and cable runs. When they get wet there is a risk of shock and fire, so keep out until the power has been checked.
Compressed, damp insulation does very little insulating, and it may not recover after it dries. Energy bills climb, and the rooms below the wet area are hotter or colder than the rest.
Soaked insulation carries a great deal of weight. The ceiling drywall under it weakens where it is fastened, and it can give way suddenly and bring the wet insulation along.
In a lot of homes the attic houses an air handler along with its condensate line and pan. A clogged drain or an overflowing pan drips into the insulation for weeks, with no storm to warn you.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (301) 287-5610Take action now and prevent costly damage. Bronx Restoration is ready to help.
Call (301) 287-5610 Now