Filing a claim is easier with good records. We document everything and talk to your adjuster for you.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
Our crews are certified, insured and equipped for crawl space water removal. They find the hidden moisture and dry it properly.
Most people who call us have never dealt with crawl space water removal before. We walk you through it on the phone, then send a local crew with the right equipment.
Water under the house is easy to miss. Most people find it when the floors feel cold and damp, a musty smell comes up through the vents, or someone opens the access hatch and sees a pond. Usually that means days of moisture in the joists already, plus insulation that is wet all the way through. We pump the space dry, remove the ruined material and get the wood dried while it is still sound.
Pumping is just half of the work. Floor joists, beams and the subfloor absorb moisture slowly and let go of it slowly, so we take moisture readings on the wood and keep dehumidifiers running until the numbers come down, usually 3 to 5 days. Our team traces the source too, whether that is a supply line leak, a drain, or rain driven groundwater, so the space stays dry afterward.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Call (301) 287-5610| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Vapor barrier | Intact plastic that can be cleaned and laid flat again | Plastic that is torn, buried in silt or holding water below it |
| Subfloor panels | Plywood that holds a screw and shows no swelling | Panels that puffed up, split into layers or crumble, particle board above all |
| Pipe insulation | Rubber or foam wrap that stayed out of the water | Soggy fiberglass pipe covering and anything exposed to sewage |
| Sill plates | Wood that reads dry on the meter and resists a probe | Stretches that are soft, crushed or eaten through by rot |
| Fiberglass batt insulation | Seldom, and just when batts never got wet and sit snug | Batts that took on water, drooped or carry a mildew odor |
What collects beneath a home is frequently dirty. A leaking drain line or groundwater carrying soil and waste is Category 2 or 3 and needs protective gear and disinfection.
Most crawl spaces carry wiring, junction boxes and HVAC ducts. Submerged wiring is a shock hazard and soaked duct insulation spreads musty air through the system.
A wet crawl space offers the soft wood and moisture that wood destroying insects and mice prefer. Once the area is dry it becomes far less inviting.
Much of what you breathe on the main level drifts up from beneath the house, carrying any mold spores and musty smells along with it.
Nobody enters until the space has been screened for shock risks, hanging ducts and contamination. Next comes charting the extent of the water and metering the joists and subfloor for moisture.
We run pumps and extraction lines until the pooled water is gone, low pockets and trenches along the footings included. Any silt or mud sitting on the liner gets removed during this step.
Debris, saturated batts and any liner that cannot be reused leave the crawl space in bags. Where mold has begun or is likely, the bare joists and subfloor get cleaned and an antimicrobial applied.
Compact fans and dehumidification work in the crawl space as long as it takes for the framing to test normal. We recheck with a meter and give you the readings and a prevention plan.
Water collects in the low spots and soaks into the soil. Batts begin drawing moisture upward and the air below the house turns humid quickly.
Mold can start on damp joists and paper faced insulation. The weight of the water drags the batts loose from the underside of the subfloor.
Humid air from below works its way up into the rooms. The lumber goes on taking in moisture, a stale smell spreads and flooring can begin to cup.
Lumber left damp this long starts breaking down. Expect softer framing, rusted fasteners, and a wet environment that draws in termites and similar pests.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (301) 287-5610Take action now and prevent costly damage. Bronx Restoration is ready to help.
Call (301) 287-5610 Now