Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
We look at the damage, explain what it needs and give you a written price before we start.
We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
Most people who call us have never dealt with wet carpet drying before. We walk you through it on the phone, then send a local crew with the right equipment.
There is always more water in a soaked carpet than the surface suggests. Often the pad is full of water and the subfloor is wet beneath it, even when the fibers you touch feel only slightly damp. What you can pull out with towels or a shop vac comes from the top, not from below. Our team in Bronx extracts the water, checks every layer with moisture meters, and sets up drying that reaches all the way down.
Two things decide if a carpet is worth saving: the cleanliness of the water and the time it has sat wet. When a clean supply line is the source and we arrive early, drying the carpet where it lies usually works. Water from an appliance counts as gray, so the pad is frequently removed while the carpet is cleaned and treated. Sewage or outside flood water means carpet and pad both come out.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (301) 287-5610| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Tack strip | Wet briefly, with no rust on the nails and no swelling | Contaminated water reached it, or it shows rust, swelling or mold |
| Drywall at the floor line | Wet only at the bottom edge, and firm again once it dries | Any mold, swelling or soft spots, or contact with gray or black water |
| Carpet | Under two days wet from a clean source, with the backing holding tight | The backing is coming apart, or it took in flood water or sewage |
| Baseboards | Wood boards still flat after drying, with no gap at the wall | Mold on the back side, or fiberboard that has swelled |
| OSB or particleboard subfloor | Edges are still flat and it reads dry after a few days | It crumbles, gives under pressure, or has swelled along the seams |
Even clean water goes bad the longer it sits. As it sits in carpet and pad it picks up soil and bacteria, so a carpet that could have been dried may have to be removed.
Mold tends to start underneath, on the carpet back, because that side stays damp and dark. You smell it long before you ever see it on top.
Wood stain and metal feet on furniture bleed into wet carpet. Those marks are often permanent, and the furniture itself wicks water and swells.
Subfloors made of OSB or particleboard puff up and fall apart if they remain wet. Weeks later, with the spill long forgotten, you get raised seams, squeaks and soft spots.
Our first job is finding the outer limit of the water, under walls and in closets too, using a thermal camera and moisture meters. Then we determine which category of water it is, as that tells us what is safe to keep.
With weighted extractors, carpet and the pad beneath it are pressed and emptied in one pass. This removes far more than a wand alone, and it shortens the drying time that follows.
Some jobs call for floating the carpet on a cushion of air, others for lifting it and taking the pad out. Air movers and dehumidifiers run until carpet and subfloor both read dry.
Where needed, an antimicrobial goes on the subfloor and carpet, then new pad is laid if the old was removed, and the carpet is stretched back on its tack strip and cleaned.
Water travels through the pad far beyond the patch you can see. It slips beneath walls into neighboring rooms while the tack strip begins to absorb it.
Bacteria in the damp pad start producing that sour wet carpet smell. Mold can begin growing on the backing and on dust trapped deep in the fibers.
Ripples appear and the carpet delaminates because the latex in its backing is breaking down. Nails in the tack strip start rusting, and the subfloor swells.
Carpet and pad left wet this long generally cannot stay. The work gets bigger, since mold is often on the subfloor and the lower edge of the drywall.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (301) 287-5610Take action now and prevent costly damage. Bronx Restoration is ready to help.
Call (301) 287-5610 Now